AX-15trans and transfer case Swap into a YJ

This write up on swapping an ax-15 trans into a YJ. Start by removing your old Trans. First you will need to get a jack stand and put it under the Trans to support it. Remove the exhaust and any wires going to the Trans and transfer case. Then remove the two Trans mount bolts that come thru the skid plate. Next remove the 6 bolts holding the skid plate on. Then unbolt the starter. Disconnect the clutch lines. Remove the 6 bolts holding the Trans to the engine. Using a jack and 2 people pull the transmissions back words and remove. To put the new Trans in reverse the steps. There is one other step. When you are putting the skid plate back in you will have to leathern the mounting holes. I would recommend using a due grinder and a carbide bit. If you have questions on this subject or any other of my write ups you can leave a comment with your email and I will get back to you

When I did mine I hade to replace the input shaft. Here are a few pics of the ax-15 when I had it apart.